4/13/2023 0 Comments Alternatives to tapdancer c64Using a tape player again the volume seemed critical. Loading is done by pressing ENTER after typing 'CLOADM', an S appears in the top left hand corner, I could see flashing so it was reading in data. ![]() I initially managed just to get a '?IO ERROR' message which happened within about 1 second. I think they might be really picky with volume. I had a try with both the 32k and 54k Dragons. Can I add a slight delay to reading the button signal? ![]() When I press 'Load' it jumps to 'Pause' and I have to press 'Load' again. Is there anything in the Arduino software I can change? I might Upload a previous version of your software to see if there is any difference. I don't think changing the variable resistor will do anything. ![]() When comparing the volume of MSX2CAS on my Smartphone to get games to load, I don't think my Casuino gets to the same volume? When the volume is fully up on my amp (bought same one as per quide, although I have not removed that capacitor) it is not as loud as the Smartphone and there is also some 'popping or clicking' so distortion from the amp? - corrupting the signal? I can't get my HX-10 to load any header from the. After rebuilding the Button Board this morning after I had made some mistake last night I got it working. As it will be printed on every PCB but there is no box to tick to say it has actually passed! Every PCB has passed QA!Īnyway back to topic.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |